hi all,
i am facing the same problem with two devices n7100 and i9300...
first of all the box was able to reach the stage of
writing 20000000 bytes to 00000000 ....ROM1
i resolder the ground wire with thick one to GND pins connected all from the box...but no luck!!!
now on both devices i am getting the following log:
EasyJtag Suite ver.: 1.0.94.0 started.
Operating system ver.: Windows XP (build 2600, Service Pack 3).
Successefuly connected to box on COM6
Box S/N: 07008016AF266685, ,FW Ver.: 01.47
Box Working Mode: JTAG Box.
Box Drivers version: 3.0.0.0, are OK
Z3X Card Serial : AA73-1CA7 , ver: 22
Writing file...E:\Jtag\Easy JTag\Samsung\I9300\EMMC_ROM1_00000000_20000000.bin
Successefuly connected to box on COM6
Box S/N: 07008016AF266685, ,FW Ver.: 01.47
Loading eMMC Addon Firmware...
CMD Pullup Level:1711 mV
CMD Active Level:2433 mV
Can't Init EMMC !!! ( Ready Condition TIMEOUT! )
error purging CDC device: 0
i checked all connections and they are fine...
hint:
1- i tried with gnd of both power supplies connected to gnd pins wires of the box then tp PCB as blang thread...
2- then i tried to connect both vcc and and vccq to the power supplies without connecting the vdd pins to vccq power supply and also with...
i followed the all instructions mentioned here...please help me in any way!!
i am facing the same problem with two devices n7100 and i9300...
first of all the box was able to reach the stage of
writing 20000000 bytes to 00000000 ....ROM1
i resolder the ground wire with thick one to GND pins connected all from the box...but no luck!!!
now on both devices i am getting the following log:
EasyJtag Suite ver.: 1.0.94.0 started.
Operating system ver.: Windows XP (build 2600, Service Pack 3).
Successefuly connected to box on COM6
Box S/N: 07008016AF266685, ,FW Ver.: 01.47
Box Working Mode: JTAG Box.
Box Drivers version: 3.0.0.0, are OK
Z3X Card Serial : AA73-1CA7 , ver: 22
Writing file...E:\Jtag\Easy JTag\Samsung\I9300\EMMC_ROM1_00000000_20000000.bin
Successefuly connected to box on COM6
Box S/N: 07008016AF266685, ,FW Ver.: 01.47
Loading eMMC Addon Firmware...
CMD Pullup Level:1711 mV
CMD Active Level:2433 mV
Can't Init EMMC !!! ( Ready Condition TIMEOUT! )
error purging CDC device: 0
i checked all connections and they are fine...
hint:
1- i tried with gnd of both power supplies connected to gnd pins wires of the box then tp PCB as blang thread...
2- then i tried to connect both vcc and and vccq to the power supplies without connecting the vdd pins to vccq power supply and also with...
i followed the all instructions mentioned here...please help me in any way!!
via Welcome to gsm-tips http://forum.gsmhosting.com/vbb/f672/i9300-dead-boot-repair-help-1757508/
Aucun commentaire:
Enregistrer un commentaire