i have just detected dead i9300 emmc check logs plz what are the next steps

EasyJtag Suite ver.: 1.1.0.0 / wxWidgets 3.1.0-W-U started.

Operating system ver.: Windows XP (build 2600, Service Pack 3).

Successefuly connected to box on COM132Box S/N: ,FW Ver.: 01.49Box Working Mode: JTAG Box.Box Drivers version: 3.0.0.0, are OK

Z3X Card Serial : AA30-71DE , ver: 22

Z3X EasyJtag Software ver. 1.1.0.0

Loading eMMC Addon Firmware...

Box S/N: ,FW Ver.: 01.49

Warning: CMD Pullup Level (1113 mV) too low , check cables etc.!!!

CMD Active Level:1495 mV

eMMC Device Information

EMMC CID : 1501003030303030305620110726589C

EMMC CSD : 902701320F5903FFF6DBFFEF8A404022

EMMC Manufacturer ID: 0015 , OEM ID: 0100

EMMC Date: 05/2005 Rev.0x56

EMMC NAME: 000000 , S/N: 537986854

EMMC ROM1 (Main User Data) Capacity: 16384 MB

EMMC ROM2 (Boot Partition 1) Capacity: 512 kB

EMMC ROM3 (Boot Partition 2) Capacity: 512 kB

EMMC RPMB (Replay Protected Memory Block) Capacity: 128 kB

Extended CSD rev 1.5 (MMC 4.41)

Boot configuration [PARTITION_CONFIG: 0x00] No boot partition configured.

Boot bus config [177]: 0x00 , width 1bit , Partition config [179]: 0x00.

Backup saved: 000000_ 537986854_20140405_1636.extcsd

Done.



these are the logs of my dead i9300 what is the next step somebody help me with success full results plz and help me finish this phone jazakAllah

via Welcome to gsm-tips http://ift.tt/ShIyYz