samsung I9300 Can't Repair Emmc name 00000

Z3X EasyJtag Software ver. 1.6.5.3

Loading eMMC Addon Firmware... IO: 1850 mV

Box S/N: 0808020E54B3EF68, ,FW Ver.: 01.50

CMD Pullup Level:1381 mV

CMD Active Level:1794 mV

eMMC Device Information

EMMC CID : 1501003030303030300C201301281062

EMMC CSD : D02701320F5903FFF6DBFFFF8E40406C

EMMC Manufacturer ID: 0015 , OEM ID: 0100

EMMC Date: 01/2013 Rev.0xc

EMMC NAME: 000000 , S/N: 538116392

EMMC ROM1 (Main User Data) Capacity: 15028 MB

EMMC ROM2 (Boot Partition 1) Capacity: 0 kB

EMMC ROM3 (Boot Partition 2) Capacity: 0 kB

EMMC RPMB (Replay Protected Memory Block) Capacity: 0 kB

Extended CSD rev 1.6 (MMC 4.5)

Boot configuration [PARTITION_CONFIG: 0x48] Boot from:ROM2 (Boot Partition 1)

Boot bus config [177]: 0x01 , width 4bits , Partition config [179]: 0x48.

Backup saved: 000000_ 538116392_20150004_2017.extcsd

Done.

Running:SAMSUNG: MoviNAND VTU00M Name 0000 Repair...



Z3X EasyJtag Software ver. 1.6.5.3

Skip loading eMMC Addon Firmware

CMD Pullup Level:1381 mV

CMD Active Level:1794 mV

Repair VTU00M eMMC:

Entering repair mode 1...

Success

Erasing repair area...

Success

Writing repair area...

Success

Exit repair mode 1...

Success

===================================

NOTE: This stage was reapir only eMMC NAME , not wear leveling data!!

NOTE: Repair Stage 2 must be done to make eMMC repair completely!

Please, Reconnect eMMC power lines and press 'VTU00M Repair' again

===================================

Running:SAMSUNG: Read S.M.A.R.T Report...



Z3X EasyJtag Software ver. 1.6.5.3

Skip loading eMMC Addon Firmware

CMD Pullup Level:1381 mV

CMD Active Level:1794 mV

Reading S.M.A.R.T

Can't init EMMC, Reason: CMD Timeout Error

===================================

via Welcome to gsm-tips http://ift.tt/1zBCCaR